.

This three-phase AC induction motor is the same size and has the same frame as the M-ACI-C200SLS but is wound for greater higher speed power output. Peak stall torque is slightly reduced and peak efficiency slightly higher. It is suitable for installation with a conventional automotive multi-speed gearbox in vehicles up to around 1250 kg. The 1 hour and peak power outputs with an 80V battery are conservatively rated at  7.5kW and just under 22kW, at around 360A peak from the battery. A cooling fan is included and there is aluminium heatsinking on the case exterior. It is possible to increase peak power to well over 25kW by increasing the current and removing the original shaft driven fan, and fitting our fan blower F-BF1, suitably controlled by the internal thermal sensor or our thermostat control TC-1.

The peak efficiency of this motor is similar to a DC motor of similar size, however, in common with many other AC induction motors it tends to maintain higher efficiency over a wider rev and load range. With a suitable matched controller, such as our CR-ACIS96 or CR-ACIC80, the torque can be tailored to achieve a very uniform curve with high stall torque. For highest voltage power use our CR-DAC2496450 controller at 96V.

Please  > click here <  for performance data.

Dimensions (approx):  > click here <  or below for outline drawing details - Weight (approx): 45 kg